fancontrol. настройка

In general, automatic mode is preferred over manual mode, as
it is more efficient and it reacts faster. Are you sure that
you want to setup this output for manual control? (n)

# pwmconfig revision 6243 (2014-03-20)
This program will search your sensors for pulse width modulation (pwm)
controls, and test each one to see if it controls a fan on
your motherboard. Note that many motherboards do not have pwm
circuitry installed, even if your sensor chip supports pwm.

We will attempt to briefly stop each fan using the pwm controls.
The program will attempt to restore each fan to full speed
after testing. However, it is ** very important ** that you
physically verify that the fans have been to full speed
after the program has completed.

Found the following devices:
   hwmon0 is k10temp
   hwmon1 is fam15h_power
   hwmon2 is radeon
   hwmon3 is asus

Found the following PWM controls:
   hwmon2/pwm1           current value: 255

Giving the fans some time to reach full speed...
Found the following fan sensors:
   hwmon3/fan1_input     current speed: 0 ... skipping!

There are no working fan sensors, all readings are 0.
Make sure you have a 3-wire fan connected.
You may also need to increase the fan divisors.
See doc/fan-divisors for more information.

root@night:~# sensors
radeon-pci-0100
Adapter: PCI adapter
temp1:        +36.0°C  (crit = +120.0°C, hyst = +90.0°C)

k10temp-pci-00c3
Adapter: PCI adapter
temp1:        +15.4°C  (high = +70.0°C)
                       (crit = +90.0°C, hyst = +87.0°C)

asus-isa-0000
Adapter: ISA adapter
cpu_fan:        0 RPM

fam15h_power-pci-00c4
Adapter: PCI adapter
power1:       28.43 W  (crit = 125.19 W)