Поставил fancontrol, запустил pwmconfig Ответил «y», на
Как теперь вернуть автоконтроль вращения кулеров, воет как сумашедший? При очередном запуске pwmconfig выдает
In general, automatic mode is preferred over manual mode, as it is more efficient and it reacts faster. Are you sure that you want to setup this output for manual control? (n)
# pwmconfig revision 6243 (2014-03-20) This program will search your sensors for pulse width modulation (pwm) controls, and test each one to see if it controls a fan on your motherboard. Note that many motherboards do not have pwm circuitry installed, even if your sensor chip supports pwm. We will attempt to briefly stop each fan using the pwm controls. The program will attempt to restore each fan to full speed after testing. However, it is ** very important ** that you physically verify that the fans have been to full speed after the program has completed. Found the following devices: hwmon0 is k10temp hwmon1 is fam15h_power hwmon2 is radeon hwmon3 is asus Found the following PWM controls: hwmon2/pwm1 current value: 255 Giving the fans some time to reach full speed... Found the following fan sensors: hwmon3/fan1_input current speed: 0 ... skipping! There are no working fan sensors, all readings are 0. Make sure you have a 3-wire fan connected. You may also need to increase the fan divisors. See doc/fan-divisors for more information.
root@night:~# sensors radeon-pci-0100 Adapter: PCI adapter temp1: +36.0°C (crit = +120.0°C, hyst = +90.0°C) k10temp-pci-00c3 Adapter: PCI adapter temp1: +15.4°C (high = +70.0°C) (crit = +90.0°C, hyst = +87.0°C) asus-isa-0000 Adapter: ISA adapter cpu_fan: 0 RPM fam15h_power-pci-00c4 Adapter: PCI adapter power1: 28.43 W (crit = 125.19 W)