bonding and linkagg

Для остальных режимов бондинга на свиче обязательно строить статическую агрегацию на ответных портах или нет? или это режим-специфично и где тогда можно посмотреть подробнее про требования к свичу для каждого режима?

http://xgu.ru/wiki/Linux_Bonding

For this section, «switch» refers to whatever system the bonded devices are directly connected to (i.e., where the other end of the cable plugs into). This may be an actual dedicated switch device, or it may be another regular system (e.g., another computer running Linux),

The active-backup, balance-tlb and balance-alb modes do not require any specific configuration of the switch.

The 802.3ad mode requires that the switch have the appropriate ports configured as an 802.3ad aggregation. The precise method used to configure this varies from switch to switch, but, for example, a Cisco 3550 series switch requires that the appropriate ports first be grouped together in a single etherchannel instance, then that etherchannel is set to mode «lacp» to enable 802.3ad (instead of standard EtherChannel).

The balance-rr, balance-xor and broadcast modes generally require that the switch have the appropriate ports grouped together. The nomenclature for such a group differs between switches, it may be called an «etherchannel» (as in the Cisco example, above), a «trunk group» or some other similar variation. For these modes, each switch will also have its own configuration options for the switch's transmit policy to the bond. Typical choices include XOR of either the MAC or IP addresses. The transmit policy of the two peers does not need to match. For these three modes, the bonding mode really selects a transmit policy for an EtherChannel group; all three will interoperate with another EtherChannel group.

Спасибо

cast psychiatrist, and tell that you have a split personality

okay

sudo cast af5

так так, посмотрим что тут у нас...
Да вроде всё в порядке