LINUX.ORG.RU
Форум — Admin  

Debian не видит сетевую карту

 ,


0

1

Добрый день Вставил сетевую карту. Делаю ifconfig, а ее там нет 

lspci
01:08.0 Ethernet controller: Intel Corporation 82562EZ 10/100 Ethernet Controller (rev 02)
01:09.0 Ethernet controller: Realtek Semiconductor Co., Ltd. Device 8339 (rev 10)
01:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8100/8101L/8139 PCI Fast Ethernet Adapter (rev 10

uname -a
Linux host 4.9.0-5-686-pae #1 SMP Debian 4.9.65-3+deb9u2 (2018-01-04) i686 GNU/Linux

Ответ на: комментарий от Pentium02 
ifconfig -a
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.1.250  netmask 255.255.255.0  broadcast 192.168.1.255
        ether 00:0e:a6:75:71:67  txqueuelen 1000  (Ethernet)
        RX packets 4896253  bytes 726241069 (692.5 MiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 5291382  bytes 1922512039 (1.7 GiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

eth1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        ether 00:a1:b0:00:9a:68  txqueuelen 1000  (Ethernet)
        RX packets 5088386  bytes 6239818525 (5.8 GiB)
        RX errors 9  dropped 51  overruns 9  frame 0
        TX packets 3719741  bytes 638833403 (609.2 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        loop  txqueuelen 1  (Local Loopback)
        RX packets 83  bytes 8086 (7.8 KiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 83  bytes 8086 (7.8 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

ppp0: flags=4305<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST>  mtu 1492
        inet 212.115.239.119  netmask 255.255.255.255  destination 212.115.225.251
        ppp  txqueuelen 3  (Point-to-Point Protocol)
        RX packets 3857418  bytes 4498001609 (4.1 GiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 2476383  bytes 500656914 (477.4 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisio
darksmoke
() автор топика
Ответ на: комментарий от redgremlin 
dmesg | grep -i firmware 
[    0.118362] pci 0000:01:09.0: [Firmware Bug]: reg 0x18: invalid BAR (can't size)
[    0.118373] pci 0000:01:09.0: [Firmware Bug]: reg 0x1c: invalid BAR (can't size)
[    0.118384] pci 0000:01:09.0: [Firmware Bug]: reg 0x20: invalid BAR (can't size)
[    0.118394] pci 0000:01:09.0: [Firmware Bug]: reg 0x24: invalid BAR (can't size)
[    0.195735] pci 0000:01:08.0: Firmware left e100 interrupts enabled; disablin
darksmoke
() автор топика
Ответ на: комментарий от yakunin 
ip link 
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DEFAULT group default qlen 1000
    link/ether 00:0e:a6:75:71:67 brd ff:ff:ff:ff:ff:ff
3: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DEFAULT group default qlen 1000
    link/ether 00:a1:b0:00:9a:68 brd ff:ff:ff:ff:ff:ff
5: ppp0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1492 qdisc pfifo_fast state UNKNOWN mode DEFAULT group default qlen 3
    link/ppp
darksmoke
() автор топика
Ответ на: комментарий от darksmoke

01:09.0 Ethernet controller: Realtek Semiconductor Co., Ltd. Device 8339 (rev 10)
pci 0000:01:09.0: [Firmware Bug]

Не повезло. Попробуй поставить ядро и фирмварь из бэкпортов.

redgremlin ★★★★★
()
Вы не можете добавлять комментарии в эту тему. Тема перемещена в архив.
Admin