(12:06) (.)(.): OpenRC 0.41.2 is starting up Gentoo Linux (aarch64)
[ 1.837720] vendor storage:20190527 ret = 0
* Mounting /proc ...
[ 1.848569] dwmmc_rockchip fe310000.dwmmc: Successfully tuned phase to 240
[ 1.851725] mmc2: queuing unknown CIS tuple 0x91 (3 bytes)
[ 1.852272] mmc2: new ultra high speed SDR104 SDIO card at address 0001
[ ok ]
* Mounting /run ...
* /run/openrc: creating directory
* /run/lock: creating directory
* /run/lock: correcting owner
* Caching service dependencies ...
[ 2.360632] cdn-dp fec00000.dp: Direct firmware load for rockchip/dptx.bin failed with error -2
[ 2.910044] scsi 0:0:0:0: Direct-Access UFD 3.0 Silicon-Power16G PMAP PQ: 0 ANSI: 6
[ 2.916328] sd 0:0:0:0: [sda] 30998528 512-byte logical blocks: (15.9 GB/14.8 GiB)
[ 2.920779] sd 0:0:0:0: [sda] Write Protect is off
[ 2.925148] sd 0:0:0:0: [sda] No Caching mode page found
[ 2.925662] sd 0:0:0:0: [sda] Assuming drive cache: write through
[ 2.944576] sda: sda1 sda2 sda3
[ 2.955299] sd 0:0:0:0: [sda] Attached SCSI removable disk
Service `netmount' needs non existent service `net'
[ ok ]
* Clock skew detected with `(null)'
* Adjusting mtime of `/run/openrc/deptree' to Sat Feb 1 09:03:33 2020
* WARNING: clock skew detected!
* Mounting /sys ...
* Remounting devtmpfs on /dev ...
[ ok ]
[ ok ]
* Mounting security filesystem ...
* Mounting /dev/mqueue ...
[ ok ]
[ ok ]
* Mounting debug filesystem ...
[ ok ]
* Mounting /dev/pts ...
* Mounting config filesystem ...
[ ok ]
[ ok ]
* Mounting fuse control filesystem ...
[ ok ]
* Mounting /dev/shm ...
[ ok ]
* Mounting persistent storage (pstore) filesystem ...
[ ok ]
cgroups | * Mounting cgroup filesystem ...
cgroups | [ ok ]
kmod-static-nodes | * Creating list of required static device nodes for the current kernel ...
udev | * Starting udev ...
kmod-static-nodes | [ ok ]
udev | [ ok ]
opentmpfiles-dev | * Setting up tmpfiles.d entries for /dev ...
opentmpfiles-dev | [ ok ]
udev-trigger | * Generating a rule to create a /dev/root symlink ...
udev-trigger | [ ok ]
udev-trigger | * Populating /dev with existing devices through uevents ...
udev-trigger | [ ok ]
* WARNING: clock skew detected!
termencoding | * Setting terminal encoding [UTF-8] ...
termencoding | [ ok ]
keymaps | * Setting keyboard mode [UTF-8] ...
hwclock | * Setting system clock using the hardware clock [UTC] ...
keymaps | [ ok ]
keymaps | * Loading key mappings [us] ...
keymaps | [ ok ]
hwclock | [ ok ]
loopback | * Bringing up network interface lo ...
hostname | * Setting hostname to localhost ...
sysctl | * Configuring kernel parameters ...
hostname | [ ok ]
fsck | * Checking local filesystems ...
sysctl | [ ok ]
loopback | [ ok ]
fsck | [ ok ]
binfmt | * Loading custom binary format handlers ...
binfmt | [ ok ]
root | * Remounting filesystems ...
root | [ ok ]
mtab | * Updating /etc/mtab ...
swap | * Activating swap devices ...
mtab | * Creating mtab symbolic link
swap | [ ok ]
mtab | [ ok ]
localmount | * Mounting local filesystems ...
localmount | [ ok ]
opentmpfiles-setup| * Setting up tmpfiles.d entries ...
opentmpfiles-setup| [ ok ]
bootmisc | * Creating user login records ...
bootmisc | [ ok ]
bootmisc | * Wiping /tmp directory ...
bootmisc | [ ok ]
save-keymaps | * Saving key mapping ...
save-termencoding | * Saving terminal encoding ...
save-termencoding | [ ok ]
save-keymaps | [ ok ]
INIT: Entering runlevel: 3
* WARNING: clock skew detected!
netmount | * ERROR: netmount needs service(s) net
local | * Starting local ...
local | [ ok ]
INIT: Id "f0" respawning too fast: disabled for 5 minutes
INIT: Id "f0" respawning too fast: disabled for 5 minutes
INIT: Id "f0" respawning too fast: disabled for 5 minutes
INIT: Id "f0" respawning too fast: disabled for 5 minutes
INIT: Id "f0" respawning too fast: disabled for 5 minutes
INIT: Id "f0" respawning too fast: disabled for 5 minutes
INIT: Id "f0" respawning too fast: disabled for 5 minutes
И висит так бесконечно...
Понимаю, что проблема тут в ините и можно сконфигурять так, чтоб работало, но у меня нет мыслей... Кто может помочь?
