Установил центос, и сразу yum update, и сразу выхлоп:
Загружены модули: fastestmirror Loading mirror speeds from cached hostfile Could not retrieve mirrorlist http://mirrorlist.centos.org/?release=7&arch=x86_64&repo=os&infra... error was 14: curl#56 - «Recv failure: Соединение разорвано другой стороной»
One of the configured repositories failed (Неизвестно), and yum doesn't have enough cached data to continue. At this point the only safe thing yum can do is fail. There are a few ways to work «fix» this:
1. Contact the upstream for the repository and get them to fix the problem.
2. Reconfigure the baseurl/etc. for the repository, to point to a working upstream. This is most often useful if you are using a newer distribution release than is supported by the repository (and the packages for the previous distribution release still work).
3. Run the command with the repository temporarily disabled yum --disablerepo=<repoid> ...
4. Disable the repository permanently, so yum won't use it by default. Yum will then just ignore the repository until you permanently enable it again or use --enablerepo for temporary usage:
yum-config-manager --disable <repoid> or subscription-manager repos --disable=<repoid>
5. Configure the failing repository to be skipped, if it is unavailable. Note that yum will try to contact the repo. when it runs most commands, so will have to try and fail each time (and thus. yum will be be much slower). If it is a very temporary problem though, this is often a nice compromise:
yum-config-manager --save --setopt=<repoid>.skip_if_unavailable=true
Cannot find a valid baseurl for repo: base/7/x86_64
64 bytes from ya.ru (87.250.250.242): icmp_seq=6 ttl=53 time=6.42 ms (DUP!) 64 bytes from 8.8.8.8: icmp_seq=1 ttl=46 time=49.3 ms (DUP!)
При первом старте системы заметил FAILED.. repo.. не успел прочитать, в логах не смог найти. Месяц на никсах, ток учусь.
помимо этой виртуалки установлено еще две, тоже центос, все работает.
Проблема решилась настройкой виртуалки. За место сетевого моста поставил нат. Но вопрос не закрыт, тк другие виртуалки работают по сетевому мосту.
И последний update. После yum update/upgrade через NAT, сменил на сетевой мост, репозитории заработали. Пинг дублируется из-за как-раз сетевого моста. Всем спасибо, вы отличные собеседники.
