топология такая.
домашний роутер tenda w316r к нему подключен комп (corei3,GA-P75-D3,1tb hard)(сервер эластикс) по витухе. на эластиксе настроен ip,dns вручную.
значит эластикс был скачен с офф сайта, Elastix 2.4.0 Stable. поставлен на отдельный хард, есть ещё второй хард на нём винда 7. в винде все пингуется стабильно.
как собственно обнаружил - подключаюсь через путти буквально пару команд успеваю ввести и всё зависает по таймауту.... если пинг пускать с эластикса на шлюз то какое то время идёт потом прекращается потом опять идёт. если с раб станции на эластикс то тоже самое.
[root@ATC ~]# ifconfig eth0 Link encap:Ethernet HWaddr 90:2B:34:6B:D6:F7 inet addr:192.168.0.15 Bcast:192.168.0.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:600 errors:0 dropped:600 overruns:0 frame:600 TX packets:319 errors:0 dropped:3 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:74419 (72.6 KiB) TX bytes:56834 (55.5 KiB) Interrupt:233 Base address:0xe000
[root@ATC ~]# mii-tool eth0 eth0: negotiated 100baseTx-FD flow-control, link ok [root@ATC ~]# ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 0 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: g Current message level: 0x00000033 (51) Link detected: yes
[root@ATC ~]# ethtool -i eth0 driver: r8169 version: 2.3LK-1-NAPI firmware-version: bus-info: 0000:03:00.0
[root@ATC ~]# ethtool --show-coalesce eth0 Coalesce parameters for eth0: Cannot get device coalesce settings: Operation not supported
[root@ATC ~]# ethtool -S eth0 NIC statistics: tx_packets: 2045 rx_packets: 5606 tx_errors: 0 rx_errors: 0 rx_missed: 10 align_errors: 0 tx_single_collisions: 0 tx_multi_collisions: 0 unicast: 2418 broadcast: 3153 multicast: 43 tx_aborted: 0 tx_underrun: 0
[root@ATC ~]# ethtool -d eth0 unknown RealTek chip
[root@ippbx ~]# lspci 00:00.0 Host bridge: Intel Corporation Xeon E3-1200 v2/3rd Gen Core processor DRAM Controller (rev 09) 00:01.0 PCI bridge: Intel Corporation Xeon E3-1200 v2/3rd Gen Core processor PCI Express Root Port (rev 09) 00:14.0 USB controller: Intel Corporation 7 Series/C210 Series Chipset Family USB xHCI Host Controller (rev 04) 00:16.0 Communication controller: Intel Corporation 7 Series/C210 Series Chipset Family MEI Controller #1 (rev 04) 00:16.3 Serial controller: Intel Corporation 7 Series/C210 Series Chipset Family KT Controller (rev 04) 00:1a.0 USB controller: Intel Corporation 7 Series/C210 Series Chipset Family USB Enhanced Host Controller #2 (rev 04) 00:1b.0 Audio device: Intel Corporation 7 Series/C210 Series Chipset Family High Definition Audio Controller (rev 04) 00:1c.0 PCI bridge: Intel Corporation 7 Series/C210 Series Chipset Family PCI Express Root Port 1 (rev c4) 00:1c.2 PCI bridge: Intel Corporation 7 Series/C210 Series Chipset Family PCI Express Root Port 3 (rev c4) 00:1d.0 USB controller: Intel Corporation 7 Series/C210 Series Chipset Family USB Enhanced Host Controller #1 (rev 04) 00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev a4) 00:1f.0 ISA bridge: Intel Corporation B75 Express Chipset LPC Controller (rev 04) 00:1f.2 SATA controller: Intel Corporation 7 Series/C210 Series Chipset Family 6-port SATA Controller [AHCI mode] (rev 04) 00:1f.3 SMBus: Intel Corporation 7 Series/C210 Series Chipset Family SMBus Controller (rev 04) 01:00.0 VGA compatible controller: NVIDIA Corporation GF106 [GeForce GTS 450] (rev a1) 01:00.1 Audio device: NVIDIA Corporation GF106 High Definition Audio Controller (rev a1) 03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 06)
заранее спасибо.
