scsi tape dat24



Привет всем Smile Вот возник хоботок с внутренним dat 24

scsi: ***** BusLogic SCSI Driver Version 2.1.16 of 18 July 2002 ***** scsi: Copyright 1995-1998 by Leonard N. Zubkoff <> scsi0: Configuring BusLogic Model BT-950 PCI Wide Ultra SCSI Host Adapter scsi0: Firmware Version: 5.02, I/O Address: 0xC000, IRQ Channel: 20/Level scsi0: PCI Bus: 0, Device: 5, Address: 0xFE9FA000, Host Adapter SCSI ID: 7 scsi0: Parity Checking: Enabled, Extended Translation: Enabled scsi0: Synchronous Negotiation: Fast, Wide Negotiation: Enabled scsi0: Disconnect/Reconnect: Enabled, Tagged Queuing: Enabled scsi0: Driver Queue Depth: 255, Scatter/Gather Limit: 128 segments scsi0: Tagged Queue Depth: Automatic, Untagged Queue Depth: 3 scsi0: SCSI Bus Termination: Both Enabled, SCAM: Disabled scsi0: *** BusLogic BT-950 Initialized Successfully *** scsi0 : BusLogic BT-950 Vendor: HP Model: C1537A Rev: L005 Type: Sequential-Access ANSI SCSI revision: 02 Loading Adaptec I2O RAID: Version 2.4 Build 5go Detecting Adaptec I2O RAID controllers... Adaptec I2O RAID controller 0 at f8880000 size=100000 irq=26 dpti: If you have a lot of devices this could take a few minutes. dpti0: Reading the hardware resource table. TID 008 Vendor: ADAPTEC Device: AIC-7899 Rev: 00000001 TID 513 Vendor: ESG-SHV Device: SCA HSBP M15 Rev: 0.10 TID 518 Vendor: IBM Device: DDYS-T18350M Rev: S93E TID 517 Vendor: IBM Device: DDYS-T36950M Rev: SA2A scsi1 : Vendor: Adaptec Model: 2100S FW:370F Vendor: IBM Model: DDYS-T18350M Rev: S93E Type: Direct-Access ANSI SCSI revision: 03 Vendor: IBM Model: DDYS-T36950M Rev: SA2A Type: Direct-Access ANSI SCSI revision: 03 Vendor: ESG-SHV Model: SCA HSBP M15 Rev: 0.10 Type: Processor ANSI SCSI revision: 02 sym0: <1010-66> rev 0x1 at pci 0000:00:01.0 irq 29 sym0: using 64 bit DMA addressing sym0: Symbios NVRAM, ID 7, Fast-80, LVD, parity checking sym0: open drain IRQ line driver, using on-chip SRAM sym0: using LOAD/STORE-based firmware. sym0: handling phase mismatch from SCRIPTS. sym0: SCSI BUS has been reset.


st: Version 20041025, fixed bufsize 32768, s/g segs 256 Attached scsi tape st0 at scsi0, channel 0, id 0, lun 0 st0: try direct i/o: yes (alignment 512 B), max page reachable by HBA 1048575

BusLogic в ядре st и ide_tape модулями


#mtx -f /dev/st0 status mtx: Request Sense: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 03 00 00 00 INQUIRY command Failed

ядро 2.6.10 есть мысли ?

Вы не можете добавлять комментарии в эту тему. Тема перемещена в архив.