Народ, а никто не помнит что нужно дописать в xorg.conf чтобы увеличить производительность видеокарты? Там что-то типа Option "nvAGP" "3" или как-то так было... забыл...
Option "NvAGP" "integer"
Configure AGP support. Integer argument can be one of:
0 : disable agp
1 : use NVIDIA's internal AGP support, if possible
2 : use AGPGART, if possible
3 : use any agp support (try AGPGART, then NVIDIA's AGP)
Please note that NVIDIA's internal AGP support cannot
work if AGPGART is either statically compiled into your
kernel or is built as a module, but loaded into your
kernel (some distributions load AGPGART into the kernel
at boot up). Default: 3 (the default was 1 until after
1.0-1251).
Release Date: 18 December 2003
X Protocol Version 11, Revision 0, Release 6.7
Build Operating System: Linux 2.4.26 i686 [ELF]
Current Operating System: Linux darkstar 2.6.10 #1 SMP Fri Jan 14 06:12:40 MSK 2005 i686
Build Date: 05 June 2004
Before reporting problems, check http://wiki.X.Org
to make sure that you have the latest version.
Module Loader present
Markers: (--) probed, (**) from config file, (==) default setting,
(++) from command line, (!!) notice, (II) informational,
(WW) warning, (EE) error, (NI) not implemented, (??) unknown.
(==) Log file: "/var/log/Xorg.0.log", Time: Sat Jan 15 02:58:43 2005
(==) Using config file: "/etc/X11/xorg.conf"
Parse error on line 8 of section Extension in file /etc/X11/xorg.conf
"Extensions" is not a valid section name.
(EE) Problem parsing the config file
(EE) Error parsing the config file
Fatal server error:
no screens found
Please consult the The X.Org Foundation support
at http://wiki.X.Org
for help.
Please also check the log file at "/var/log/Xorg.0.log" for additional information.
Я сначала пробовал как ты написал (Extensions), потом попробовал без s на конце. Сам не знаю зачем :) Так вот, лог записался без s, а я потом подправил туда, где ошибка. Поэтому там "2 весии"
Посмотри если такое же то все пучком
cat /proc/driver/nvidia/agp/status
Status: Enabled
Driver: NVIDIA
AGP Rate: 8x
Fast Writes: Enabled
SBA: Enabled
Если нет то echo "options nvidia NVreg_EnableAGPSBA=1 NVreg_EnableAGPFW=1" >> modprobe.conf
А у меня ошибка там какая-то...
wishmaster@darkstar:~$ cat /proc/driver/nvidia/agp/status
Status: Disabled
AGP initialization failed, please check the ouput
of the 'dmesg' command and/or your system log file
for additional information on this problem.
> Если нет то echo "options nvidia NVreg_EnableAGPSBA=1 NVreg_EnableAGPFW=1" >> modprobe.conf
Люди, кончайте вращаться - не даст вам FW и SBA (см. NvWorld.ru FAQ) видимого прироста производительности. Это из разряда сказок про супербыструю Gentoo :-))
Лучше оверклокингом займитесь, если уж так прижало...