LILO не устанавливается

man lilo, man lilo.conf на предмет опции lba

boot=/dev/hda
map=/boot/map
install=/boot/boot.b
prompt
timeout=50
message=/boot/message
lba32
default=linux

image=/boot/vmlinuz-2.4.0-0.43.6
label=linux
initrd=/boot/initrd-2.4.0-0.43.6.img
read-only
root=/dev/hda5

other=/dev/hda1
label=dos

This example shows a system configured to boot two operating systems: Red Hat Linux and DOS. Here is a deeper look at a few of the lines of this file:

*

boot=/dev/hda tells LILO to install itself on the first hard disk on the first IDE controller.
*

map=/boot/map locates the map file. In normal use, this should not be modified.
*

install=/boot/boot.b tells LILO to install the specified file as the new boot sector. In normal use, this should not be altered. If the install line is missing, LILO will assume a default of /boot/boot.b as the file to be used.
*

The existence of prompt tells LILO to show you whatever is referenced in the message line. While it is not recommended that you remove the prompt line, if you do remove it, you can still get a prompt by holding down the [Shift] key while your machine starts to boot.
*

timeout=50 sets the amount of time that LILO will wait for user input before proceeding with booting the default line entry. This is measured in tenths of a second, with 50 as the default.
*

message=/boot/message refers to the screen that LILO displays to let you select the operating system or kernel to boot.
*

lba32 describes the hard disk geometry to LILO. Another common entry here is linear. You should not change this line unless you are very aware of what you are doing. Otherwise, you could put your system in an unbootable state.
*

default=linux refers to the default operating system for LILO to boot from the options listed below this line. The name linux refers to the label line below in each of the boot options.
*

image=/boot/vmlinuz-2.4.0-0.43.6 specifies the linux kernel to boot with this particular boot option.
*

label=linux names the operating system option in the LILO screen. In this case, it is also the name referred to by the default line.
*

initrd=/boot/initrd-2.4.0-0.43.6.img refers to the initial ram disk image that is used at boot time to actually initialize and start the devices that makes booting the kernel possible. The initial ram disk is a collection of machine-specific drivers necessary to operate a SCSI card, hard drive, or any other device needed to load the kernel. You should never try to share initial ram disks between machines.
*

read-only specifies that the root partition (see the root line below) is read-only and cannot be altered during the boot process.
*

root=/dev/hda5 tells LILO what disk partition to use as the root partition.

Спасибо - все получилось
Вот мой окончательный вариант :
boot=/dev/hda
map=/boot/map
install=/boot/boot.b
prompt
delay=25
message=/boot/message
lba32

default=FC3

image=/boot/vmlinuz-2.6.9-1.667
label=FC3
initrd=/boot/initrd-2.6.9-1.667.img
read-only
root=/dev/hdb10

image=/mnt/Suse/boot/vmlinuz
label="Suse"
root=/dev/hdb7
initrd=/mnt/Suse/boot/initrd

other=/dev/hda1
label="windows"
table=/dev/hda

Визуально это выглядит так , что при загрузке вылетает менюшка из 3 пунктов на выбор
Супер