Не могу понять, почему в NetworkManager галка «Enable wireless» не активна
# lshw -class network
*-network
description: Network controller
product: BCM4313 802.11b/g/n Wireless LAN Controller
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:03:00.0
version: 01
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list
configuration: driver=bcma-pci-bridge latency=0
resources: irq:17 memory:b1900000-b1903fff
*-network
description: Ethernet interface
product: RTL8111/8168 PCI Express Gigabit Ethernet controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:04:00.0
logical name: eth0
version: 06
serial: f0:de:f1:51:1f:8f
size: 100Mbit/s
capacity: 1Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=full firmware=rtl_nic/rtl8168e-2.fw ip=192.168.4.194 latency=0 link=yes multicast=yes port=MII speed=100Mbit/s
resources: irq:43 ioport:2000(size=256) memory:b1804000-b1804fff memory:b1800000-b1803fff
*-network DISABLED
description: Wireless interface
physical id: 3
logical name: wlan0
serial: c0:f8:da:02:b7:33
capabilities: ethernet physical wireless
configuration: broadcast=yes driver=brcmsmac driverversion=3.8.10-1-ARCH firmware=N/A link=no multicast=yes wireless=IEEE 802.11bgn
# ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DEFAULT qlen 1000
link/ether f0:de:f1:51:1f:8f brd ff:ff:ff:ff:ff:ff
3: wlan0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN mode DEFAULT qlen 1000
link/ether c0:f8:da:02:b7:33 brd ff:ff:ff:ff:ff:ff
# ip link set dev wlan0 up
RTNETLINK answers: Operation not possible due to RF-kill