LINUX.ORG.RU

journald.conf(5):

RateLimitIntervalSec=, RateLimitBurst=

Configures the rate limiting that is applied to all messages generated on the system. If, in the time interval defined by RateLimitIntervalSec=, more messages than specified in RateLimitBurst= are logged by a service, all further messages within the interval are dropped until the interval is over. A message about the number of dropped messages is generated. This rate limiting is applied per-service, so that two services which log do not interfere with each other’s limits. Defaults to 10000 messages in 30s. The time specification for RateLimitIntervalSec= may be specified in the following units: «s», «min», «h», «ms», «us». To turn off any kind of rate limiting, set either value to 0.

intelfx ★★★★★
()
Ответ на: комментарий от intelfx

спасибо. я читал невнимательно

router ★★★★★
() автор топика
Вы не можете добавлять комментарии в эту тему. Тема перемещена в архив.