Wifi не работает в режиме точки доступа

03:00.0 Network controller: Broadcom Corporation BCM43225 802.11b/g/n (rev 01)
	Subsystem: Broadcom Corporation Device 04da
	Kernel driver in use: wl

random: Trying to read entropy from /dev/random
Configuration file: /etc/hostapd/hostapd.conf
nl80211: interface wlan0 in phy phy0
rfkill: initial event: idx=3 type=1 op=0 soft=0 hard=0
nl80211: Register frame command failed (type=208): ret=-95 (Operation not supported)
nl80211: Register frame match - hexdump(len=2): 04 0a
nl80211: Failed to register Action frame processing - ignore for now
nl80211: Add own interface ifindex 11
nl80211: Set mode ifindex 11 iftype 3 (AP)
nl80211: Failed to set interface 11 to mode 3: -95 (Operation not supported)
nl80211: Interface already in requested mode - ignore error
nl80211: Create interface iftype 6 (MONITOR)
Failed to create interface mon.wlan0: -95 (Operation not supported)
nl80211: Driver does not support monitor interface type - try to run without it
BSS count 1, BSSID mask 00:00:00:00:00:00 (0 bits)
nl80211: Regulatory information - country=00
nl80211: 2402-2472 @ 40 MHz
nl80211: 2457-2482 @ 40 MHz
nl80211: 2474-2494 @ 20 MHz
nl80211: 5170-5250 @ 40 MHz
nl80211: 5735-5835 @ 40 MHz
nl80211: Added 802.11b mode based on 802.11g information
Completing interface initialization
Mode: IEEE 802.11g  Channel: 8  Frequency: 2447 MHz
nl80211: Set freq 2447 (ht_enabled=0 sec_channel_offset=0)
nl80211: Failed to set channel (freq=2447): -95 (Operation not supported)
Could not set channel for kernel driver
wlan0: Unable to setup interface.
Flushing old station entries
Could not connect to kernel driver.
Deauthenticate all stations
nl80211: Frame command failed: ret=-95 (Operation not supported) (freq=0 wait=0)
netlink: Operstate: linkmode=0, operstate=6
nl80211: Set mode ifindex 11 iftype 2 (STATION)