Стоит gentoo 2006.0 (2.6.15). Делал какие-то установки (в упор не помню что:) и тв я больше не вижу. Конфиг, видимо, религия не позволила сохранить:( Симптомы: однообразные помехи с 6 по 20й каналы в независимости от того, какой тюнер, карточка, стандарт или таблица каналов выбрана.
riban # lspci | grep Philips 00:0d.0 Multimedia controller: Philips Semiconductors SAA7130 Video Broadcast Decoder (rev 01)
riban # lsmod Module Size Used by tuner 44068 0 saa7134 111328 0 tda9887 15504 0 pcspkr 2692 0 nvidia 4086256 12 via_ircc 25236 0 rtc 11956 0 video_buf 18308 1 saa7134 v4l2_common 5760 1 saa7134 v4l1_compat 14724 1 saa7134 ir_kbd_i2c 7692 1 saa7134 ir_common 9220 2 saa7134,ir_kbd_i2c videodev 8576 1 saa7134
riban # cat /etc/modules.autoload.d/kernel-2.6 tda9887 secam=d port2=0 port1=1 saa7134 card=57 tuner=38 gbuffers=4
cat /usr/src/linux/.config | grep -i i2c CONFIG_I2C=m CONFIG_I2C_CHARDEV=m CONFIG_I2C_ALGOBIT=m CONFIG_I2C_VIA=m CONFIG_I2C_VIAPRO=m CONFIG_I2C_DEBUG_CORE=y CONFIG_I2C_DEBUG_ALGO=y CONFIG_I2C_DEBUG_BUS=y CONFIG_I2C_DEBUG_CHIP=y
riban # cat /usr/src/linux/.config | grep -i saa7134 CONFIG_VIDEO_SAA7134=m CONFIG_VIDEO_SAA7134_ALSA=m
riban # v4l-info /dev/video0 ### video4linux device info [/dev/video0] ### general info VIDIOCGCAP name : "Avermedia AVerTV GO 007 FM" type : 0x2f [CAPTURE,TUNER,TELETEXT,OVERLAY,CLIPPING] channels : 3 audios : 0 maxwidth : 720 maxheight : 578 minwidth : 48 minheight : 32
channels VIDIOCGCHAN(0) channel : 0 name : "Television" tuners : 1 flags : 0x1 [TUNER] type : TV norm : 2 VIDIOCGCHAN(1) channel : 1 name : "Composite1" tuners : 0 flags : 0x0 [] type : CAMERA norm : 2 VIDIOCGCHAN(2) channel : 2 name : "S-Video" tuners : 0 flags : 0x0 [] type : CAMERA norm : 2
tuner VIDIOCGTUNER tuner : 0 name : "Television" rangelow : 0 rangehigh : 4294967295 flags : 0x7 [PAL,NTSC,SECAM] mode : SECAM signal : 0
riban # dmesg | grep -i saa saa7130/34: v4l2 driver version 0.2.14 loaded saa7130[0]: found at 0000:00:0d.0, rev: 1, irq: 16, latency: 32, mmio: 0xe3003000 saa7130[0]: subsystem: 1461:d109, board: Avermedia AVerTV GO 007 FM [card=57,insmod option] saa7130[0]: board init: gpio is 10600 input: saa7134 IR (Avermedia AVerTV GO as /class/input/input2 saa7130[0]: i2c eeprom 00: 61 14 09 d1 ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 20: 13 02 ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff tuner 0-0061: chip found @ 0xc2 (saa7130[0]) saa7130[0]: registered device video0 [v4l2] saa7130[0]: registered device vbi0 saa7130[0]: registered device radio0 saa7130[0]/irq[10,-66478]: r=0x20 s=0x00 PE saa7130[0]/irq: looping -- clearing PE (parity error!) enable bit saa7130/34: v4l2 driver version 0.2.14 loaded saa7130[0]: found at 0000:00:0d.0, rev: 1, irq: 16, latency: 32, mmio: 0xe3003000 saa7130[0]: subsystem: 1461:d109, board: Avermedia AVerTV GO 007 FM [card=57,insmod option] saa7130[0]: board init: gpio is 10605 input: saa7134 IR (Avermedia AVerTV GO as /class/input/input4 saa7130[0]: i2c xfer: < f5 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < 8f ERROR: NO_DEVICE saa7130[0]: i2c xfer: < 84 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < 86 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < 96 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < a0 00 > saa7130[0]: i2c xfer: < a1 =61 =14 =09 =d1 =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =13 =02 =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff =ff > saa7130[0]: i2c eeprom 00: 61 14 09 d1 ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 20: 13 02 ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7130[0]: i2c xfer: < 84 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < 86 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < 94 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < 96 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < c0 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < c2 ><7>saa7130[0]/irq[10,8286]: r=0x20 s=0x10 PE saa7130[0]/irq: looping -- clearing PE (parity error!) enable bit tuner 0-0061: chip found @ 0xc2 (saa7130[0]) saa7130[0]: i2c xfer: < c4 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < c6 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < c8 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < ca ERROR: NO_DEVICE saa7130[0]: i2c xfer: < cc ERROR: NO_DEVICE saa7130[0]: i2c xfer: < ce ERROR: NO_DEVICE saa7130[0]: i2c xfer: < d0 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < d2 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < d4 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < d6 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < d8 ERROR: NO_DEVICE saa7130[0]: i2c xfer: < da ERROR: NO_DEVICE saa7130[0]: i2c xfer: < dc ERROR: NO_DEVICE saa7130[0]: i2c xfer: < de ERROR: NO_DEVICE saa7130[0]: registered device video0 [v4l2] saa7130[0]: registered device vbi0 saa7130[0]: registered device radio0
Смотреть пытаюсь с помощью tvtime и xawtv. Подскажите, куда копать, уже неделю бьюсь над ним.