LINUX.ORG.RU

Aircrack-ng помощь

 


0

2

Вообщем решил заняться этим делом, ниже будут команды которые я вводил и сама ошибка

root@kirin:/home/kiri# iwconfig
enp2s0    no wireless extensions.

lo        no wireless extensions.

wlan0     IEEE 802.11abgn  ESSID:"TP-LINK_8538"  
          Mode:Managed  Frequency:2.427 GHz  Access Point: EC:08:6B:6F:85:38   
          Bit Rate=1 Mb/s   Tx-Power=20 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:on
          Link Quality=70/70  Signal level=-32 dBm  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:90   Missed beacon:0

root@kirin:/home/kiri# airmon-ng start wlan0

Found 3 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to run 'airmon-ng check kill'

  PID Name
19857 wpa_supplicant
21659 NetworkManager
21698 dhclient

PHY	Interface	Driver		Chipset

phy0	wlan0		ath10k_pci	Qualcomm Atheros Device 0042 (rev 30)

		(mac80211 monitor mode vif enabled for [phy0]wlan0 on [phy0]wlan0mon)
		(mac80211 station mode vif disabled for [phy0]wlan0)

root@kirin:/home/kiri# airmon-ng check kill

Killing these processes:

  PID Name
19857 wpa_supplicant

root@kirin:/home/kiri# iwconfig
enp2s0    no wireless extensions.

lo        no wireless extensions.

wlan0mon  IEEE 802.11abgn  Mode:Monitor  Frequency:2.457 GHz  Tx-Power=0 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Power Management:on

root@kirin:/home/kiri# wash -i wlan0mon

Wash v1.5.3 WiFi Protected Setup Scan Tool
Copyright (c) 2011, Tactical Network Solutions, Craig Heffner
mod by t6_x<t6_x@hotmail.com>, DataHead, Soxrok2212, Wiire, AAnarchYY & rofl0r

BSSID              Ch  dBm  WPS  Lck  ESSID
--------------------------------------------------------------------------------
E4:3E:D7:D3:FF:0E   1  -79  1.0  No   MiFibra-FF0C
98:97:D1:7F:A0:34   1  -75  1.0  No   MOVISTAR_A033
D4:7B:B0:92:12:0D   1  -86  1.0  No   MOVISTAR_120C
E0:41:36:1F:88:0E   1  -86  1.0  No   AMADEO
EC:08:6B:6F:85:38   4  -33  1.0  No   TP-LINK_8538
^C 

тем временем в другом окне

root@kirin:/home/kiri# aireplay-ng -1 5 -a EC:08:6B:6F:85:38 wlan0mon
No source MAC (-h) specified. Using the device MAC (AC:E0:10:81:D4:B5)
20:51:27  Waiting for beacon frame (BSSID: EC:08:6B:6F:85:38) on channel 4

20:51:28  Sending Authentication Request (Open System)

20:51:30  Sending Authentication Request (Open System)

20:51:32  Sending Authentication Request (Open System)

20:51:34  Sending Authentication Request (Open System)

20:51:36  Sending Authentication Request (Open System)

20:51:38  Sending Authentication Request (Open System)

20:51:40  Sending Authentication Request (Open System)

20:51:42  Sending Authentication Request (Open System)

20:51:44  Sending Authentication Request (Open System)

20:51:46  Sending Authentication Request (Open System)

20:51:48  Sending Authentication Request (Open System)

20:51:50  Sending Authentication Request (Open System)

20:51:52  Sending Authentication Request (Open System)

20:51:54  Sending Authentication Request (Open System)

20:51:56  Sending Authentication Request (Open System)

20:51:58  Sending Authentication Request (Open System)
Attack was unsuccessful. Possible reasons:

    * Perhaps MAC address filtering is enabled.
    * Check that the BSSID (-a option) is correct.
    * Try to change the number of packets (-o option).
    * The driver/card doesn't support injection.
    * This attack sometimes fails against some APs.
    * The card is not on the same channel as the AP.
    * You're too far from the AP. Get closer, or lower
      the transmit rate. 

а в первом

[+] Waiting for beacon from EC:08:6B:6F:85:38
[+] Switching wlan0mon to channel 4
[+] Associated with EC:08:6B:6F:85:38 (ESSID: TP-LINK_8538)
[+] Starting Cracking Session. Pin count: 0, Max pin attempts: 11000
[+] Trying pin 12345670
[+] Sending EAPOL START request
[!] WARNING: Receive timeout occurred
[+] Sending EAPOL START request
[!] WARNING: Receive timeout occurred
[+] Sending EAPOL START request

и так постоянно, пробовал reaver запускать с командой --no-nacks и т.д, ничего не помогает, какие идейки есть?



Последнее исправление: fffggg5055 (всего исправлений: 1)

Ответ на: комментарий от anonymous

только испанский)ну а так вижу что бьет ошибку во втором окне в терминале, но я не думаю что моя карта не подходит для этого дельца, ведь для wifiphisher подходит

fffggg5055
() автор топика
Вы не можете добавлять комментарии в эту тему. Тема перемещена в архив.