Gentoo не видит сетевую карточку

Приветствую!

Обновляю ядро 2.6.18-r6 -> 2.6.23-r3.
В системе 3 сетевые карточки. 2 заработали, 1 - нет.
Не заработала встроенная гигабитная Marvell 88E8001.
Как и в предыдущем ядре выбрал драйвер SK98LIN (вкомпиленный в ядро, не модулем).

lspci видит (!!), dmesg ниче не выдает, ifconfig соответственно тоже.
Пробовал очищать /etc/udev/rules.d/70-persistent-net.rules - не помогло.

mmt@nanorobocop-server ~ $ ifconfig -a
eth0      Link encap:Ethernet  HWaddr 00:13:46:5F:1F:5C  
          inet addr:169.254.139.21  Bcast:169.254.255.255  Mask:255.255.0.0
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:5 Base address:0xc00 

eth1      Link encap:Ethernet  HWaddr 00:E0:4C:45:5A:AF  
          inet addr:192.168.1.100  Bcast:192.168.1.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:7142 errors:0 dropped:0 overruns:0 frame:0
          TX packets:10310 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:908655 (887.3 Kb)  TX bytes:13901229 (13.2 Mb)
          Interrupt:10 Base address:0x2800 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:56 errors:0 dropped:0 overruns:0 frame:0
          TX packets:56 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:4520 (4.4 Kb)  TX bytes:4520 (4.4 Kb)

mmt@nanorobocop-server ~ $ lspci | grep -i eth
01:0a.0 Ethernet controller: VIA Technologies, Inc. VT6105 [Rhine-III] (rev 8b)
01:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
01:0d.0 Ethernet controller: Marvell Technology Group Ltd. 88E8001 Gigabit Ethernet Controller (rev 13)

mmt@nanorobocop-server ~ $ dmesg | grep -i eth
Parsing all Control Methods:
Table [DSDT](id 0001) - 512 Objects with 44 Devices 139 Methods 18 Regions
Initializing Device/Processor/Thermal objects by executing _INI methods:
Executed 0 _INI methods requiring 0 _STA executions (examined 50 objects)
eth0: VIA Rhine III at 0xfbfffc00, 00:13:46:5f:1f:5c, IRQ 5.
eth0: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000.
8139cp: 10/100 PCI Ethernet driver v1.3 (Mar 22, 2004)
8139too Fast Ethernet driver 0.9.28
eth1: RealTek RTL8139 at 0xe0012800, 00:e0:4c:45:5a:af, IRQ 10
eth1:  Identified 8139 chip type 'RTL-8100B/8139D'
eth0: link down
eth1: link up, 100Mbps, full-duplex, lpa 0x41E1

mmt@nanorobocop-server ~ $ cat /etc/udev/rules.d/70-persistent-net.rules 
# This file was automatically generated by the /lib/udev/write_net_rules
# program, probably run by the persistent-net-generator.rules rules file.
#
# You can modify it, as long as you keep each rule on a single line.


# PCI device 0x10ec:0x8139 (8139too)
SUBSYSTEM=="net", DRIVERS=="?*", ATTR{address}=="00:e0:4c:45:5a:af", NAME="eth1"

# PCI device 0x1106:0x3106 (via-rhine)
SUBSYSTEM=="net", DRIVERS=="?*", ATTR{address}=="00:13:46:5f:1f:5c", NAME="eth0"