Gentoo, kernel 2.6.15. Всё сделал по официальной хаутушке: http://www.gentoo.org/doc/en/usb-guide.xml. Все необхдимый модули вкомпилировал в ядро. Ядро не включает емуляцию скази для USB. dmesg, в часности, показывает, что вот это:
(SCSI emulation automatically kicks in)
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
(Now the device information including model number is retrieved)
usb-storage: waiting for device to settle before scanning
Vendor: JetFlash Model: TS512MJF2A Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 1003600 512-byte hdwr sectors (514 MB)
(The write-protect sense is EXPERIMENTAL code in the later kernels)
sda: Write Protect is off
sda: Mode Sense: 0b 00 00 08
sda: assuming drive cache: write through
SCSI device sda: 1003600 512-byte hdwr sectors (514 MB)
/dev/scsi/host0/bus0/target0/lun0: p1
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0
usb-storage: device scan complete
(At this point, the device is generally accessible by mounting /dev/sda1)
отсутствует. Несмотря на то, что вот эти опции в ядре:
Device Drivers --->
SCSI device support --->
(Although SCSI will be enabled automatically when selecting USB Mass Storage,
we need to enable disk support.)
--- SCSI support type (disk, tape, CD-ROM)
<*> SCSI disk support
были включены в ядре. Как мне включить эмуляцию скази? Сообщением ниже полный листинг dmesg.