Help, Debian убивает жесткий диск (hp mini 110-300)

WD Green?

Debian убивает жесткий диск

Дебиану это убийство невыгодно. Наверняка заказчики в Fedora!

man hdparm

vendor seagate

хоть подскажите в какой etc смотреть

etc/hdparm.conf

# -B apm setting #apm = 255

для «вообще»

-B Get/set Advanced Power Management feature, if the drive supports it. A low value means aggressive power management and a high value means better performance. Possible set‐ tings range from values 1 through 127 (which permit spin-down), and values 128 through 254 (which do not permit spin-down). The highest degree of power management is attained with a setting of 1, and the highest I/O performance with a setting of 254. A value of 255 tells hdparm to disable Advanced Power Management altogether on the drive (not all drives support disabling it, but most do).

для WD

-J Get/set the Western Digital (WD) Green Drive's «idle3» timeout value. This timeout controls how often the drive parks its heads and enters a low power consumption state. The factory default is eight (8) seconds, which is a very poor choice for use with Linux. Leaving it at the default will result in hundreds of thousands of head load/unload cycles in a very short period of time. The drive mechanism is only rated for 300,000 to 1,000,000 cycles, so leaving it at the default could result in premature failure, not to mention the performance impact of the drive often having to wake-up before doing routine I/O.

WD supply a WDIDLE3.EXE DOS utility for tweaking this setting, and you should use that program instead of hdparm if at all possible. The reverse-engineered implementation in hdparm is not as complete as the original official program, even though it does seem to work on at a least a few drives. A full power cycle is required for any change in set‐ ting to take effect, regardless of which program is used to tweak things.

A setting of 30 seconds is recommended for Linux use. Permitted values are from 8 to 12 seconds, and from 30 to 300 seconds in 30-second increments. Specify a value of zero (0) to disable the WD idle3 timer completely (NOT RECOMMENDED!).

PS:

FILES /etc/hdparm.conf

255 это не есть good. Оно вообще APM вырубает.

это запрет частоты парковки головок.

и параноя в кустах

забей. здоровье дороже

Спасибо. Классное решение проблемы.

Парковкой голов занимается фирмваре диска и сделать её некорректно не может ни одна ОС.

Тема продублирована в разделе Linux-hardware.

Решение так и не найдено, но и причин бить в барабаны тоже нет, или уже нет, или это мало кого интересует.