SANE теряется

В SUSE 10.0 почему-то перестал работать USB-сканер Epson Stylus CX-3200.

mikhail@linux:~> sudo sane-find-scanner
Password:

  # No SCSI scanners found. If you expected something different, make sure that
  # you have loaded a SCSI driver for your SCSI adapter.
  # Also you need support for SCSI Generic (sg) in your operating system.
  # If using Linux, try "modprobe sg".

found USB scanner (vendor=0x04b8 [EPSON], product=0x0802 [USB MFP]) at libusb:001:003
  # Your USB scanner was (probably) detected. It may or may not be supported by
  # SANE. Try scanimage -L and read the backend's manpage.

  # Not checking for parallel port scanners.

  # Most Scanners connected to the parallel port or other proprietary ports
  # can't be detected by this program.
mikhail@linux:~> sudo scanimage -L

No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
mikhail@linux:~> cat /etc/sane.d/epson.conf
# epson.conf
#
# here are some examples for how to configure the EPSON backend
#
# SCSI scanner:
scsi EPSON
#
# Parallel port scanner:
#pio 0x278
#pio 0x378
#pio 0x3BC
#
# USB scanner:
# There are two different methods of configuring a USB scanner: libusb and the kernel module
# For any system with libusb support (which is pretty much any recent Linux distribution) the
# following line is sufficient. This however assumes that the connected scanner (or to be more
# accurate, it's device ID) is known to the backend.
usb
# For libusb support for unknown scanners use the following command
# usb <product ID> <device ID>
# e.g.:
# usb 0x4b8 0x110
# And for the scanner module, use the following configuration:
#usb /dev/usbscanner0
#usb /dev/usb/scanner0
mikhail@linux:~>

Пробовал прописывать usb 0x4b8 0x802, перегружаться - то же самое. Где может быть проблема?